Table of Contents
Advertisement
Industrial PCs MCR5000
10
F
USE REPLACEMENT
Please follow this procedure for replacing the fuse inside the device:
Disconnect all cables between the MCR 5000 and its TFT or plasma display.
Warning:
Make sure the power plug has been disconnected before starting disassembly.
L
OCATION OF THE FUSE
The MCR 5000 fuse is located in the position highlighted in the picture.
R
EMOVING THE FUSE
In order to remove the fuse inside the MCR 5000 device, please push a suitable tool (e.g. a
screw driver) into the red marked area in order to release the lock, as shown in the figure.
Keep the fuse retainer slightly pushed in and twist it until reaching the notch at the device.
The fuse retainer can now be removed.
R
EPLACING THE FUSE
You can now remove the fuse from the fuse retainer and replace it with the same type of
fuse. The type of fuse to be used is:
Vendor: Littelfuse
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • D-72622 Nürtingen
41
Advertisement
Table of Contents
