Table of Contents
Advertisement
3.1.5.3 Power Management
This field allows you to select the type (or degree) of power saving
by changing the length of idle time that elapses before the "HDD
Power Down" field is activated.
Min Saving
Max Saving
User Define
3.1.5.4 Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC + Blank This will cause the system to turn off the
Blank Screen
DPMS Support Initializes display power management signaling.
3.1.5.5 HDD Power Down
After the set time of system inactivity, the hard disk drive will be
powered down while all other devices remain active.
3.1.5.6 Soft-Off by PBTN
This field allows you to select the method of powering off your
system.
Delay 4 Sec Regardless of whether the Power Management field
Minimum power saving time for HDD Power Down
= 15 min.
Maximum power saving time for HDD Power
Down = 1 min.
Allows you to set the power saving time in the
"HDD Power Down" field.
vertical and horizontal synchronization ports
and write blanks to the video buffer.
This only writes blanks to the video buffer.
Select this if your video board supports it.
is enabled or disabled, if the power button is
pushed and released in less than 4 sec, the system
enters the Suspend mode. The purpose of this
function is to prevent the system from powering off
in case you accidentally "hit" or pushed the power
button. Push and release again in less than 4 sec to
restore. Pushing the power button for more than 4
seconds will power off the system.
Award BIOS Setup Utility
3
73
Advertisement
Table of Contents
