Lubrication; Chain Case - Arctic Cat PANTERA 7000 2015 Operator's Manual

Chain Case


NOTE: The snowmobile must be
on a level surface for this procedure.
Check the lubricant level in the chain
case by using the sight glass.

NOTE: The correct level is when
the lubricant is at least halfway up in
the sight glass.

NOTE: Adding lubricant can be
done by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for this service.
This service is at the discretion and
expense of the snowmobile owner
Pantera 7000, ZR 4000
LXR

NOTE: Make sure the snowmobile
is fully shifted into forward.
1. If the lube level is low, remove the
three screws securing the shift actua-
tor to the chain case, disconnect the
actuator wiring harness, and remove
the actuator extension, shift detent,
and spring; then add appropriate
amount of Arctic Cat Synthetic
Chain Lube (p/n 6639-539) through
the shift actuator opening until the
lube is halfway up the sight glass.
2. Install the actuator extension and
gently rotate counter clockwise to
make sure the shift fork is in the for-
ward position.
3. Remove the actuator extension; then
re-install the actuator extension
making sure the notch in the exten-
sion is directed downward.

Lubrication

4. Install spring into the bottom of

NOTE: Rotate the extension clock-
wise approximately 20° making sure
not to pull out the extension when
rotating. This is only to aid in the
installation of the actuator.
5. Install the actuator and secure using
6. Connect the harness to the gear posi-
0746-115
.
7. Start the engine and verify proper

NOTE: If excessive build-up of
moisture
detected in the chain case, it may be
necessary to replace the lube.
ZR 4000 RR
1. If the lube level is low, remove the
detent block and install into the
chain case cover. The notch in the
extension should be lined up with
the notch in the block.
the existing three torx screws
(threads coated lightly with blue
Loctite #243). Tighten to 36 in-lb.
tion sensor; then secure the connec-
tor to the main harness using a cable
tie.
reverse and forward operation by shift-
ing in and out of reverse three times.
or discolored
fill plug from the chain case; then
add the appropriate amount of Arctic
Cat Synthetic Chain Lube (p/n 6639-
539) in the fill hole. Install the plug.
0748-259
oil is
0746-471
25