BRAILLO
NORWAY AS
●
4.17 Paper feed assembly, adjustment
If for some reason the paper feed mechanism has been disassembled it could be that the paper will not
stop correctly on the marks on the paperguide.
Therefore, it is necessary to adjust the relation between the paper parking position and where the
stepping motor is parking.
Loosen the paper feed shaft by unscrewing the two left-hand screws (B) on the sensor wheel.
Note ! Do not loosen the screws for the stepping motor shaft.
Put a sheet of paper into the tractors on the paper feed.
Now the tractor feed shaft can be turned forward or backward until the paper is in the desired position.
Tighten the screws (B) again.
64
T RACTOR
B
B 400 Series 3
S TEPPING
MOTOR