Removal Of Cover - Braillo 400 S 3 Series User Manual

BRAILLO NORWAY AS
●
2.2

Removal of cover

See fi gures below and on the next pages.
The cover is constructed of a aluminium frame which is fastened with four screws (G) under the
baseboard of the printer, there are one screw in each corner. Onto this frame the sides, front and back
t panels are fastened. Some of these panels can be taken off for a better access e.g. for smaller repairs
or to connect to the electrical unit.
However, if the printer is going to be lifted or moved, and the printers own wheels cannot be used, the
cover must be taken off completely.
It can be done like this:
Disconnect the mains.
Open the panel (A) by turning the seven screws (B) 1/4 of a revolution - use a coin or a screwdriver.
Pull out the panel. Place it aside.
G
8
A A
G
B 400 Series 3
B
G