During Printing; Intermittent Problem - Braillo 400 S 3 Series User Manual

B 400 Series 3
BRAILLO NORWAY AS
●

During printing:

If a defective magnet is detected during printing, the printer will not stop. Instead it will give an audio
alarm, and display a message like the one in the example below.
You can also see from the way the information is displayed, if this magnet is constantly defective,
or if the problem is intermittent. There will be information in the bottom line in the display as long
as the problem is present.
The sheet counter will show how many sheets that have been printed since the problem fi rst occurred.
If the problem disappears, the information on the bottom line will also disappears.
Constant defect magnet:
When the magnet(s) is constant defective, the display will indicate where the problem is located, the
number of sheets since the problem fi rst occured, how many defective magnets, and the exact position
of the magnet in the magnet rack.
When the printer stops, the information in the display will remain until you press "Reset printer". If
the defective magnet has not been replaced, the printer will proceed as described in the "On power-on
or reset" section.

Intermittent problem:

The bottom line in the display will only be displayed as long as the problem is present. If the problem
disappears, the information on the bottom line also disappears.
See the fi gure below:
Mag . Rack A 45
However, the printer will still remember where the problem was, and the information can be displayed
after the printer has stopped. Do not use "Reset printer", this will clear the information from the printers
memory! Stop the printer by stopping the text sent from the computer and wait for it to fi nish. When the
printer stops, the display will not show the bottom line, but by pressing the "Fine Adjust" button on the
control panel, the information will appear on the bottom line in the display.
30