Heat Sink And Fans - HP OMEN 15 Maintenance And Service Manual

Heat sink and fans

NOTE: The heat sink and fans are spared together.
Component
Heat sink and fans (includes replacement thermal material)
Before replacing the heat sink and fans, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery (see
Remove the heat sink and fans:
1. Disconnect the cables from the system board for the left (1) and right (2) fans.
2. Remove the two Phillips PM2.0×3.5 screws (3) that secure each fan to the computer.
3. Loosen the six captive Phillips screws (4) on the heat sink.
4. Lift the fans and heat sink straight up and out of the computer (5).
Bottom cover on page
Disconnecting the battery on page
23).
25).
Spare part number
788600-001
Heat sink and fans 29