Solid-State Drive (M.2) - HP OMEN 15 Maintenance And Service Manual

Solid-state drive (M.2)

Description
128 GB solid-state drive (SSD), M.2.2280, TLC, SATA
256 GB solid-state drive (SSD), M.2.2260, MLC, PCIe
512 GB solid-state drive (SSD), M.2.2280, MLC, PCIe
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.5 screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
28 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Disconnecting the battery on page
23).
25).
Spare part number
788611-001
788612-001
788613-001