Wlan Module - HP OMEN 15 Maintenance And Service Manual

WLAN module

Component
Intel Wireless 7260BN 802.11 bgn 2x2 WiFi + BT 4.0 Combo Adapter
Intel Dual Band Wireless-AC 7260(non v-Pro) 802.11 AC 2x2 WiFi + BT 4.0 Combo Adapter
Before replacing the WLAN module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery (see
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
2. Remove the Phillips PM2.0×3.0 screw (2) that secures the WLAN module to the system board.
3. Remove the WLAN module (3) by pulling the module away from the slot.
NOTE: If the WLAN antenna cable is not connected to the terminal on the WLAN module, a protective sleeve
should be installed on the antenna connector, as shown in the following illustration.
26 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Disconnecting the battery on page
23).
25).
Spare part number
784640-006
784645-006