Configuring Osd Settings - HIKVISION DS-7604NI-E1 User Manual

DS-7600 Series NVR User's Manual
2. Select the camera to setup VCA Alarm in using the camera dropdown list.
3. Check the Enable VCA Alarm checkbox.
4. Press the Set button to set up linkage action.
1) Select the Arming Schedule tab to set the arming schedule. Up to 8 periods can be configured.
If the same schedule can be applied in other days, click Copy.
2) Select the Linkage Action tab to set the actions to take if VCA event is detected. The detail
instruction of the actions, please refer to Page 75.
5. Click the Apply button to save the settings. Click OK to back to the previous menu.
6. Click the Apply button on the VCA interface to save the settings.

Configuring OSD Settings

On Screen Display (OSD) settings can be configured in the OSD menu. The OSD is shown in each
display in Live Feed and Playback mode.
To configure OSD settings:
1. Enter the OSD menu, shown in Figure 87 by going to Menu > Cameras Setup > OSD.
Figure 86.1 VCA Menu
89