Fitting The Plinth Facing; Fitting The Air Separator - Miele F 1471 Vi Operating And Installation Instructions

Fitting the plinth facing

Do not cover the vents in the plinth.
This will damage the appliance.
^ Trim the plinth facing to the required
length and height (cut along the
lower edge of the plinth facing where
it touches the floor).
^ Secure the plinth to the appliance,
and attach the cover discs supplied.
^ Now fit the plinth facing.

Fitting the air separator

The air separator in the vent
underneath separates air entering the
appliance from that leaving it. It also
stops warm air flowing into the
appliance, which would cause a short
circuit.
^ If necessary, the three parts of the air
separator can be shortened to the
correct height.
^ Refit the foam parts in the sides.
^ Open the appliance door.
^ Clip the air separator to the
appliance door from below, making
sure it clicks into position.
Installation
77