Table of Contents
Advertisement
Fitting the plinth facing
Do not cover the vents in the plinth.
This could result in damage to the
appliance.
^ Trim the plinth facing to the required
length and height (cut along the
lower edge of the plinth facing where
it touches the floor).
^ Secure the plinth to the appliance,
and attach the cover caps supplied.
^ Now fit the plinth facing.
Fitting the air separator
The air separator at the bottom of the
ventilation grille separates air entering
the appliance from that leaving it.
It also stops warm air flowing into the
appliance, which would cause a short
circuit.
^ If necessary the three parts of the air
separator can be shortened to the
correct height.
^ Replace the foam parts in the sides.
^ Open the appliance door.
^ Clip the air separator to the
appliance door from below, making
sure it clicks into position.
Installation
81
Hide quick links:
Advertisement
Table of Contents
