Miele F 1471 Vi Operating And Installation Instructions page 42

Problem solving guide
. . . the 0 symbol flashes in the
control panel of the ice/water
dispenser.
The drip tray of the ice/water dispenser
is full.
^ Empty the drip tray.
. . . the control panel is misted up.
The heater element behind the control
panel is switched off.
^ Switch the de-misting function back
on again (see "Ice/Water dispenser").
. . . the ice/water dispenser doesn't
switch on.
^ Check whether the appliance is
connected to the electricity supply.
. . . the ice/water dispenser is not im-
mediately ready for use after the
appliance has been switched on.
This is not a fault.
After opening and closing the
appliance door, it may take a few
seconds before the ice/water dispenser
can be used again.
. . . the ice/water dispenser doesn't
produce ice cubes or chilled water.
^ Check whether the appliance has
been switched on.
^ Check whether the ice/water
dispenser is switched on.
^ Check whether the system lock for
the ice/water dispenser has been
activated (the 0 symbol is
highlighted yellow in the control
panel).
42
^ Check whether the appliance is
correctly connected to the mains
water supply.
^ Was the water inlet pipe purged of air
by a qualified and competent person
before the appliance was used for
the first time?
^ Check whether the water inlet is
open.
^ Check that the ice cube container is
positioned correctly.
^ Check that the temperature in the
freezer section is low enough.
^ Check whether there is sufficient
water pressure. The water pressure
(flow rate) must be between 1.72 and
5.0 bar.
^ Check that the correct valve was
installed; an incorrect valve may
cause a drop in water pressure.
^ Check whether the ice cube
separating function is switched on. If
the ice is not separated by the
spindle in the ice cube container at
regular intervals, it may freeze
together and block the dispensing
spout (see "Ice/Water dispenser").
Remember it can take up to
10 hours to produce the first ice
cubes.