Pillion Seat - Triumph Trophy Handbook

Pillion Seat

chsv
1. Seat lock
The seat lock is located on the rear
mudguard, below the rear light unit.
Remove the Pillion Seat
Insert the ignition key into the seat lock and
turn it anti-clockwise. This will release the seat
from its lock.
If heated seats are fitted, lift the seat to allow
access to the seat heating connector and
disconnect the connector.
chsu_1
1. Heated seat connector
Lift the seat upwards and rearwards to
remove it from the motorcycle.
Refit the Seat
If fitted, reconnect the seat heating connector.
Engage the seat's two outer brackets under
the loops on the subframe and the two inner
brackets to tangs on the rider's seat.
Ensure that if the rider's seat is in the low
1
position, the tangs (see page 74) are fitted to
the lower slots, and if the rider's seat is in the
high position the tangs are fitted to the upper
slots.
Gently push the seat forwards and press
down at the rear to engage in the seat lock.
chsy
1. Pillion seat brackets
1
2. Front seat slots - seat in high position
3. Front seat slots - seat in low position
To prevent detachment of the seat during
riding, after fitting always grasp the seat
and pull firmly upwards. If the seat is not
correctly secured, it will detach from the
lock.
A loose or detached seat could cause loss
of motorcycle control and an accident.
General Information
2
1
3
Warning
2
1
3
73