Deactivating Cruise Control; Resuming The Cruise Control Set Speed - Triumph Trophy Handbook

General Information

Deactivating Cruise Control

The cruise control can be deactivated by one
of the following methods:
• Roll the throttle fully forward;
• Pull the clutch lever;
• Operate the front or rear brake;
• Increase speed by using the throttle for
more than 60 seconds;
• Press and release the on/off button on
the right hand switch cube.
Provided the cruise control has not been
deactivated by turning the ignition switch to
the OFF position, the previous set speed can
be resumed by pressing and releasing the
RES/+ end of the adjust button. The
motorcycle speed has to be between
30 to 100 mph (48 to 160 km/h) and in
4th gear or higher.
58
Resuming the Cruise Control Set
Speed
Warning
When resuming cruise control, always
ensure that the traffic conditions are
suitable for the set speed.
Using cruise control in heavy traffic, on
roads with sharp/blind bends or when they
are slippery, may result in loss of
motorcycle control and an accident.
Provided the cruise control has not been
deactivated by turning the ignition switch to
the OFF position, the previous set speed can
be resumed by pressing and releasing the
RES/+ end of the adjust button provided the
the conditions described on page
been met.
1
chdc
1. Cruise control ON/OFF button
2. Cruise control adjust button, SET/-
3. Cruise control adjust button, RES/+
The set speed will remain in the cruise control
memory until the ignition switch has been
turned to the OFF position.
57 have
3
2