How To Ride The Motorcycle; To Stop The Engine; To Start The Engine - Triumph Trophy Handbook

How to Ride the Motorcycle

To Stop the Engine

3
1. Engine stop switch
2. Starter button
3. Neutral indicator light
4. ON position
5. Ignition switch
Close the throttle completely.
Select neutral.
Turn the ignition switch off.
Select first gear.
Support the motorcycle on a firm, level
surface with the side or centre stand.
Lock the steering.
Caution
The engine should normally be stopped by
turning the ignition switch
OFF position. The engine stop switch is for
emergency use only. Do not leave the
ignition switched on with the engine
stopped. Electrical damage may result.
96
1
P
2

To Start the Engine

Check that the engine stop switch is in the
RUN position.
Ensure the transmission is in neutral.
Turn the ignition switch on.
Note:
• When the ignition is switched on,
the tachometer and speedometer
needles will quickly sweep from zero
to maximum and then return to
zero. The instrument warning lights
will illuminate and will then go off
(except
remain on until the engine starts -
see 'Warning Lights' on page 24). It
is not necessary to wait for the
to the
needle to return to zero before
starting the engine.
4
5
those which normally