Hazard Warning Lights; Throttle Control - Triumph Trophy Handbook

General Information

Hazard Warning Lights

To turn the hazard warning lights on or off,
press and release the hazard warning light
switch on the instruments.
The ignition must be switched on for the
hazards warning lights to function, but will
remain on if the ignition is switched off until
the hazard warning light switch is pressed
again.
1
1. Hazard warning light switch
66

Throttle Control

3
2
1
1. Throttle open position
2. Throttle closed position
3. Cruise control cancel position
This Triumph model has an electronic throttle
twist grip to open and close the throttles via
the engine control unit. There are no direct-
acting cables in the system.
The throttle grip has a resistive feel to it as it is
rolled rearwards to open the throttles. When
the grip is released it will return to the throttle
closed position by its internal return spring
and the throttles will close.
From the closed position, the throttle twist
grip can be rolled forwards 3 - 4 mm to
deactivate the cruise control (see page 58).
There are no user adjustments for the throttle
control.
If there is a malfunction with the throttle
control the malfunction indicator light (MIL)
becomes illuminated and
following engine conditions may occur:
• MIL illuminated, restricted engine RPM
and throttle movement;
• MIL illuminated, limp home mode with
the engine at a fast idle condition only;
• MIL illuminated, engine will not start.
one of the