Trip Computer 1 And 2 - Triumph Trophy Handbook

General Information

Trip Computer 1 and 2

There are two sets of trip computer data,
shown as TRIP 1 and TRIP 2.
Each trip displays the same sets of data
independently of the other trip. It is possible
to:
• Reset each set of trip data independently.
Trip 2 can also be
automatically, after an adjustable time
delay of between 1 and 8 hours;
• Select which three trip data items are
shown on each trip display screen.
The top and bottom lines of each trip display
are selected from the SETTINGS menu and
are then permanently displayed, when that
trip screen is being displayed. When that trip
screen is displayed it is then possible to scroll
through the list of remaining trip items to
change what is shown on the centre line.
If a trip item is permanently displayed on the
top or bottom line it will not be displayed
again on the centre line.
1
2
3
chsb_2
1. SCROLL button, up
2. SCROLL button, down
3. SELECT button
38
Press and release the SCROLL button on the
left hand switch cube until the desired display
is highlighted.
1
set to reset
chdo
1. Trip computer centre line
2. Trip computer fixed lines
The display will scroll through in the following
order when pressing down on the SCROLL
button (it will scroll through in the reverse
order if up on the button is pressed):
• Journey distance;
• Journey time;
• Average speed;
• Instantaneous fuel consumption;
• Average fuel consumption;
• Fuel used;
• Range to empty;
• Odometer;
• Digital speedometer (upper display line
only);
• Tyre
Monitoring System (TPMS) is fitted
(centre display line only);
• Triumph Electronic Suspension (TES)
Settings - Trophy SE (centre display line
only).
N 2
10:08 26°C
TRIP 1
0
MPH
144.2
1892
ODO
2
pressures - if Tyre Pressure