Table of Contents
Advertisement
maximum.
14. Press MODE/ESC to exit and save your edited scene into the fixtures internal
memory. The number of steps can be defined under "EDIT" and the scenes
can be called up under "Run." To run the scenes see page 30.
Editing procedure 2: Using an external controller.
1.
Call up the first scene in your controller now.
2.
Select "SC01" by pressing the UP or DOWN buttons.
3.
Press MODE/ESC, the display shows "SC01".
4.
Press MODE/ESC, the display shows "C-01".
5.
Select "CEDT" by pressing the UP or DOWN buttons.
6.
Press MODE/ESC, the display shows "OFF".
7.
Press UP, the display will read "ON".
8.
Press MODE/ESC, the display shows "SC02". You successfully
downloaded the first scene.
9.
Adjust the Step-time as described above.
10. Call up the second scene in your controller now.
11. Repeat steps 5-11 until all desired scenes are downloaded.
12. Press MODE/ESC to exit. The number of steps can be defined under
"STEP" and the scenes can be called up under "RUN."
-
-
１３
XM605-V1.0-NR
Advertisement
Table of Contents
