Elation WW TONE Manual page 14

Edit Scenes – This function allows the user to edit or define the actual scenes
that are stored in the user defined built-in programs that are accessed in the
previous
CEDT - Edit program using a external controller.
Editing procedure 1: Using the control board only.
1. Access the main menu.
2. Tap the UP button until "EDIT" is displayed and press ENTER.
3. The display will show "SC-01", this stands for the scene number. For example,
"SC-01" is displayed, it means you will be editing scene 1, press ENTER. You
can change the scene number by tapping the UP button.
4. Press ENTER, the display will show "C-01," this represents the channel
number. If "C-01" is displayed, you will be editing the fixture's channel 1
value of the selected scene, press ENTER. You can change the channel
number by tapping the UP button.
5. The display will show the DMX value for the channel that is being edited. It will
be displayed as "11XX," it stands for Channel 11 of the editing scene, the
DMX value is "XX."
6. Adjust the DMX value by tapping the UP button, until you get the expected
effect for this channel.
7. Press ENTER to enter the editing of the other channels of the scene.
8. Repeat steps 5-8, until you finish setting all the DMX values for all the
channels of this scene, each scene can have 16 channels maximum.
9. Once all the channels are completed, the display will begin to flash "TIME,"
this indicates the time needed to run this scene.
10. Press ENTER to edit the time needed, the display shows "TXXX", "XXX"
represents the time needed to run this scene. For example, "T002" means
scene 1 needs 0.4 seconds to run, "T-15" means this scene needs 3.0
seconds to run. Note: "XX" is always 0.2 seconds not one second.
11. Adjust the time needed by tapping the UP button.
12. Press ENTER to save the settings for the scene you are editing, the display
will change to the next scene automatically.
13. Repeat steps 3-12 to edit other scenes, you can edit and save 48 scenes
step.
- -
１２
XM605-V1.0-NR