Ecofeedback - Miele heat pump dryer Operating Instructions Manual

EcoFeedback

You can use the EcoFeedback sensor
to call up information about the energy
consumption of your dryer.
Touching the EcoFeedback sensor will
call up two types of information:
– an estimate of the consumption be‐
fore the programme begins
– the energy consumption during the
programme.
The EcoFeedback sensor will light up
and information will appear in the dis‐
play.
Both will go out automatically a few
seconds later or alternatively they can
be confirmed with OK.
At the end of the programme, before
opening the door, you can also call up
the following in the display:
– the energy consumption and
– the degree of soiling of the fluff filters
and the plinth filter (0 % = light, 50 %
= medium, 100 % = heavy). Accumu‐
lating fluff and soiling will cause the
programme duration to increase
which in turn will increase energy
consumption.
1. Estimate
 After selecting a programme, touch
the EcoFeedback sensor.
For a few seconds bars which indicate
the estimated consumption will appear:
Energy
The more bars visible, the higher the
energy consumption.
The estimate will vary depending on the
programme and any options selected.
20
2. Actual consumption
 Touch the EcoFeedback sensor.
You can view the actual amount of en‐
ergy used.
Example:
Energy 2,0
< 0.1 kWh will be displayed if the ener‐
gy consumption is very low.
The consumption will vary depending
on the programme stage and residual
moisture present.
If the door is opened or the tumble
dryer has switched off automatically
at the end of the programme, the da‐
ta will revert to the estimated con‐
sumption.
Total consumption setting
– shows consumption data for the pro‐
gramme which has just been run
and
– shows total energy consumption to
date.
See "Settings menu" for more detailed
information.
kWh