Plinth Filter; Removing The Plinth Filter; Cleaning The Plinth Filter - Miele heat pump dryer Operating Instructions Manual

Heat pump dryers
Hide thumbs Also See for heat pump dryer:
Table of Contents

Advertisement

Cleaning and care

Plinth filter

Only clean the plinth filter when
Clean out airways lights up.
To delete Clean out airways: Switch the
dryer off and back on again / confirm
OK.

Removing the plinth filter

 Press the round, indented area on the
heat exchanger access panel to open
it.
The panel will spring open.
 Pull the plinth filter out by the handle.
42
Removing the plinth filter will cause the
right hand guide pin in the dryer to
come out. This pin ensures that the
heat exchanger access panel can only
be closed if the plinth filter is inserted
the right way round.

Cleaning the plinth filter

 Pull the handle out of the plinth filter.
 Clean the filter thoroughly under run‐
ning water.
 Squeeze the plinth filter thoroughly.
The plinth filter must not be re‐
placed dripping wet as this can
cause a fault.
 Use a damp cloth to remove any fluff
from the handle.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tmb640Tmg 440 wp

Table of Contents