Problem Solving Guide; Messages In The Display - Miele heat pump dryer Operating Instructions Manual

Problem solving guide

With the help of the following notes minor faults in the performance of the appli‐
ance, some of which may result from incorrect operation, can be put right without
contacting the Service Department.

Repair work to electrical appliances must only be carried out by a suitably
qualified person in strict accordance with current local and national safety regu‐
lations. Repairs and other work by unqualified persons could be dangerous.
The manufacturer cannot be held liable for unauthorised work.
Some of the messages in the display are more than one line long. Touch the  or
 sensor to read them in full.

Messages in the display

Problem
 lights up after
switching on

Adjust the load See 
lights up after a pro‐
gramme is cancelled

 Service Fault F
lights up after a pro‐
gramme is cancelled
Problem

Clean out airways
up at the end of a pro‐
gramme
50
Cause and remedy
Access via a code has been activated.
 See "Settings menu, Code".
This is not a fault.
In some programmes, if the drum has been underloa‐
ded or is empty, the programme will be cancelled.
This can also happen if the items are already dry.
 Open and close the door to resume drying.
 Dry individual items using the Warm air timed dry‐
ing programme.
No obvious cause.
 Switch the dryer off and then on again.
 Start a programme.
If the programme is cancelled again and an error
message appears, there is a fault. Contact the Miele
Service Department.
Cause and remedy
lights There is a build-up of fluff in the airways.
 Clean the fluff filters.
 Clean the plinth filter.
See "Cleaning and care".
To switch off the message:
 Confirm with OK.