BMW R 1200 RT Rider's Manual page 83

0 °C, disengage the clutch after
switching on the ignition.
The start attempt is auto-
matically interrupted if bat-
tery voltage is too low. Recharge
the battery before you start the
engine, or use jump leads and a
donor battery to start.
The engine starts.
If the engine refuses to start,
consult the troubleshooting
chart in the section entitled
"Technical data". (
Pre-ride check
The instrument panel runs a test
of the 'General' warning light
when the ignition is switched on:
this is the "Pre-Ride-Check" The
test is aborted if you start the
engine before it completes.
Phase 1
General warning light shows
red.
CHECK!
play.
Phase 2
General warning light shows
yellow.
CHECK!
play.
144) with cruise-control system:
SET light shows.
If the 'General' warning light does
not show:
Some malfunctions cannot
be indicated if the 'Gener-
al' warning light cannot be dis-
played.
Check that the 'General' warning
light comes on, and that it shows
red and yellow.
appears on the dis-
appears on the dis-
Have the fault rectified as
quickly as possible by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
ABS self-diagnosis
BMW Motorrad Integral ABS per-
forms self-diagnosis to ensure
its operability. Self-diagnosis is
performed automatically when
you switch on the ignition. The
motorcycle has to move forward
at a speed above 5 km/h for the
wheel sensors to be tested.
Phase 1
Test of the diagnosis-compat-
ible system components with
the motorcycle at a standstill.
ABS warning light flashes.
Possible national variant of
the ABS warning light.
5
81
z