BMW R 1200 RT Rider's Manual page 133

The mirrors can easily work
loose from their anchoring
if the rubber holders or snap-fit
studs are greased.
Do not grease the rubber holder
or snap-fit stud.
Install the mirror in the mirror
housing, making sure that the
three plugs all engage in their
corresponding mounts.
Check that the bulb is cor-
rected seated (by looking in
through the headlight lens).
Replacing brake-light,
rear light and rear-
indicator bulbs
If it is not standing firmly,
the motorcycle could topple
in the course of the operations
described below.
Always make sure that the
motorcycle is stable and firmly
supported.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove screws 1 on left and
right.
Pull the bulb housing to the
rear until it is clear of holders 2.
8
131
z