Troubleshooting And Technical Support - Minolta DiMAGE Scan Dual III AF-2840 Instruction Manual

Konica minolta dimage scan dual iii instruction manual
Table of Contents

Advertisement

T
ROUBLESHOOTING AND TECHNICAL SUPPORT
This section covers minor problems with scanner operation. For major problems or damage, or if a
problem continues to reoccur frequently, contact your dealer or a Minolta service facility.
SYMPTOM or MESSAGE
When starting up the utility software, Error=4 –
could-not-confirm-scanner-connection message
appears.
When starting up the utility software, an error mes-
sage appears.
• The utility software freezes.
• The scanning time increases.
Unusual image color when scanning color negative
film.
The scanned image is not sharp.
Cannot-verify-home-position message appears dur-
ing scanning.
Cannot scan APS film, and initial loading failed. The
error-during-film-transportation or error-during-
rewind message appears.
The scanner indicator lamp blinks rapidly.
The set-holder message appears.
The holder-does-not-match-selected-film message
appears.
The film-not-found-in-APS-holder message
appears.
The preview image displays unusual color repro-
duction.
For Macintosh
When Pixel Polish is active, the image blacks out or
"Insufficient memory. Pixel Polish processing failed,"
message appears.
86
SOLUTION
Confirm the cable is securely connected between the comput-
er and scanner. Turn the scanner off and on. Click OK to con-
tinue.
Close the scanner door. Click OK to continue.
Turn off the scanner. Shut down the image-processing appli-
cation and increase its memory allocation. Restart the com-
puter and scanner.
Confirm color negative film is selected in the main window,
and rescan the image, or color balance the image using the
DiMAGE Scan Dual III Utility's image-processing tools. If the
problem is not solved, reinstall the scanner utility software.
Select an autofocus option in the preference window, or use
point AF or manual focus.
The film holder was hindered during the scan. Turn off the
scanner, and restart the computer.
Press the eject button on the scanner, and remove the APS
adapter after rewinding is completed. Reinsert the holder into
the scanner. If the problem persists, remove the adapter and
do not insert it again; it may damage the film or scanner.
Close the door, and shut down and restart the scanner, utility,
and application.
Reload the holder into the scanner.
Set the correct film format in the DiMAGE Scan Dual III Utility
or insert the correct holder into the scanner.
Insert an APS cassette into the APS adapter.
Remove the film holder and close the scanner door. Press
shift+control+I (Windows) or command+shift+I (Macintosh) to
reinitialize the scanner.
Increase the amount of the system's largest unused block of
memory to more than 128MB. See instructions on the facing
page.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dimage scan dual iii

Table of Contents