Specifications; Performance - AE Techron 8101 Operator's Manual

8101 OPERATOR'S MANUAL

7 Specifications

Specifications are for units in Dual mode driving
both channels into 8-ohm loads, (26 dB = 20
times voltage gain) and operating from 120 VAC,
unless otherwise specified.
"Standard 1 kHz Power" refers to maximum
average power in watts at 1 kHz with 0.1% THD.
"Full Bandwidth Power" refers to maximum
average power in watts from 20 Hz to 20 kHz with
0.1% THD.

7.1 Performance

Frequency Response:
± 0.25 dB from 20 Hz to 20 kHz at 1 watt.
Signal to Noise Ratio:
< 105 dB (ref. rated power, 20 Hz to 20 kHz, A-
weighted).
Total Harmonic Distortion (THD):
<0.35% at full rated power, from 20 Hz to 20
kHz.
I.M. Distortion:
<0.35% at 60 Hz and 7 kHz at 4:1, from -40 dB
to full rated power.
Crosstalk:
>80 dB (below rated power) 20 Hz to 1 kHz.
DC Output Offset:
< 2 mV
Input Impedance (nominally balanced, nominally
unbalanced):
10 k ohms, 5 k ohms.
Common Mode Rejection (CMR) (20Hz to 1kHz,
typical):
50 dB
Maximum Input Voltage:
± 10 V balanced or unbalanced
20
Load Impedance:
Dual: 2, 4, 8, 16 Ohm
Bridge Mono: 4, 8, 16 Ohm
Gain Control (when enabled, switch selectable):
Voltage gain adjustable from 20 to 0 or from 63
to 0.
Required AC Mains (+15%, -25%):
120V/60Hz, 230V/50Hz.
Power Draw at Idle (120 VAC mains):
35W (Standby Mode).
Overall Group Delay:
< 120 usec
Operating Temperature:
10°C to 50°C (50°F to 122°F), maximum
output power de-rated above 30°C (86°F).
Humidity:
70% or less, non-condensing.
Cooling:
Front-to-back airflow.
Chassis:
The amplifier is designed for stand-alone or
rack-mounted operation. The chassis is
aluminum with a black powder-coat finish. The
unit occupies two EIA 19-inch-wide units.
Dimensions:
Width - 19 inches (48.3 cm)
Height – 3.5 inches (8.9 cm)
Depth – 14.25 inches (36.2 cm)
Net Weight:
27.0 lbs. (12.3 kgs.)
Shipping Weight:
32.0 lbs. (14.5 kgs.)
Information subject to change 97-8101002_9-13-12