Specifications; Performance; Ac Power; Input - AE Techron LV 3620 Operator's Manual

1.3 Specifications

1.3.1 Performance

Note: The following applies to 120 Vac units with a 24 ohm load and a
voltage gain of 30, unless specified otherwise.
Configuration: Dual channel, voltage mode, floating output operation.
Voltage gain: 30 or 60, ±0.2%, internally selectable.
Bandwidth: dc to > 50 kHz; +0, –1 dB from 5 Hz to 30 kHz.
Differential phase error: < 0.1° @ 60 Hz (unit to unit).
THD: <0.1%
THD + N: : < 0.1% at 600 Hz, full output of power.
Phase response: ±10° from 10 Hz to 20 kHz at 1 watt.
Signal-to-noise ratio: 100 dB below rated output (20 Hz to 20 kHz).
IM Distortion (IMD): Less than 0.05% from 10 milliwatts to full rated
output.
Damping factor: Greater than 1,000 from 10 Hz to 400 Hz.
Slew rate: Greater than 30 volts per microsecond
Load impedance: Rated for greater than 2 ohm usage only.

1.3.2 AC power

Input power requirements: 120/230 Vac, 15 A, 1–phase, 50–60 Hz, ±10%.

1.3.3 Input

Common-mode input: ±11 volts dc maximum.
CMRR: –70 db minimum, 40 to 600 Hz.
Input impedance: Nominally 50 kΩ, differential.
Input connector: Balanced, 3–terminal barrier block connector.
Preinstallation
LV3620
1–4