Correct microphone level
To the left the LED for indication of the microphone sensitivity of the mic input is located.
If the mic sensitivity control is correctly set, this LED shall light up at program peaks. If no
microphone is connected this LED is disabled.
Loop current
At the centre of the front panel the LED for loop current is located. This LED is blinking
according to the program material and indicates that the loop is not broken. Please note
that this LED only indicates that there is current floating in the loop, not that the level is
sufficient.
The volume thumb wheel and the bass and treble controls are also located at the front
panel.
Listen to music with headphones
Univox® DLS-50 with its built-in automatic volume control (AGC) is developed for superior
speech intelligibility when used as a loop amplifier. However, while listening to music with
your hearing aid/s in T position, the sound might be unsatisfactory. This happens because
most hearing aids limit certain frequencies, for example bass tones, which might result in a
flat sound without nuances.
You can receive a richer more nuanced sound if you take off your hearing aid/s and instead
listen to the music with headphones connected to the headphones outlet in the rear panel.
The quality enhancement resulting from listening with headphones depends on the type of
hearing impairment you have and the type of headphones you use.
Security/warranty
Basic knowledge in audio and video installation techniques is required to achieve existing
regulations. The installer/planner is responsible for the installation hereby avoiding any risk
or cause of fire.
Please (also) note that warranty is not valid for any damage or defects on the product due
to incorrect or incautious installation (or usage).
9