Connect The Univox® Dls-33Tv; Connecting The Loop Pad/Sofa Loop To The Amplifier; Connecting The Amplifier To The Tv - Univox DLS-33TV User Manual

Connect the Univox® DLS-33TV
(3) (8) (9)

Connecting the loop pad/sofa loop to the amplifier

1. Place the loop pad on or under the seat cushion where you usually sit and watch TV.
Place the sofa loop cable on the floor/under the carpet around the sofa.
2. Lay the loop cable so that it reaches the amplifier, which should be placed behind the
TV. To reduce risk of tripping on the loop cable, run it along the wall or under a carpet.
Extension cables are available as accessories if necessary.
3. Connect the loop pad/sofa loop plug to the loop port (1) on the DLS-33TV.
4. Remove the Scart from the TV and connect it to the Scart socket (2) on the short side
of the DLS-33TV.

Connecting the amplifier to the TV

1. Connect the DLS-33TV's Scart (3) to the TV's Scart socket number 1.
2. If the TV does not have a Scart socket, connect a cable from the TV's audio output to
any of the IN inputs (4) in the DLS-33(SC)/DLS-33TV(SC).
3. A third way of transmitting the sound from the TV to the DLS-33TV is to connect the
electret microphone 13A to any of the IN inputs (4). The microphone can then be
attached to the TV loudspeaker.
4. Connect the Switching power adapter's wire to the amplifier socket marked 12V AC
or C
4
Front side
(7)
(10)
(5)
Rear side
(2)
(6)
(11) (4) (1) (5) (3)