Automatic Scart Connection - Univox DLS-50 User Manual

If you instead want to connect the audio output of your TV (RCA) to the amplifier, purchase
an audio cable with double RCA connectors at one end and a 3.5mm connector at the other
end (Audio cable, see section Accessories). To connect your stereo to the Univox® DLS-50
you need the same cable.
Microphone
If a microphone should be used, for example to make it possible for someone else to talk to
you while using the loop, it should be connected to the special microphone input (Mic). The
microphone shall be an electret type microphone (13B or 13C, see section Accessories).
It's also possible to pick up TV or stereo sound by attaching a special microphone on the
speaker grid (13A, see section Accessories). This microphone is normally connected to
the combined mic/line input (Mic/Line) but can also be connected to the special mic input
(Mic) if you want to adjust the input level. Take off the paper cover of the loose round
velcro pad and attach it to the speaker grid of the TV. Then use the attached velcro pad on
the microphone to attach it onto the speaker. The microphone will then automatically be
directed inwards and pick up the sound from the speaker. If you want to pick up the sound
of a surround system with the 13A microphone, attach it to the centre speaker.
Switched power supply
Connect the switched power supply to the output for mains power in the rear panel (12V
AC/DC). Finally connect the power supply to a power outlet.

Automatic Scart connection

If you want to connect Univox® DLS-50 to the Scart output of your TV you should start
with buying a special Scart connector, Univox® AutoScart. Univox® AutoScart always gives
you the right sound in the loop, regardless if you watch TV through your digibox, cable or
satellite or watch DVD or VHS (part no. 284016, see section Accessories).
If you already have a Univox® AutoScart, be sure that your TV works as intended with your
VCR/DVD/satellite receiver/digibox. All units connected to your TV's Scart output must
be serial connected (see example of serial connection below). If there are several Scart
outputs on your TV you shall always connect Univox® AutoScart to the Scart output no. 1
on your TV.
6