Table of Contents
Advertisement
Room loop
The loop cable can for example be attached with the clips included on the floor trim along
the walls of the room. It can also be placed under the carpet or in the ceiling. The loop
should not be positioned at mid height (approx. 1m above the floor) as this will influence
the performance of the system. Connect the wire ends at the loop terminal in the rear
panel. Wire area = 0,33mm
.
2
See the outputs in the rear panel at the previous picture.
Connect Univox® DLS-50 to your TV and/or other
sound source
Univox® DLS-50 has two inputs (3.5mm) that can be used to connect your TV, stereo or
other sound source and a special microphone input (3.5mm), which makes it possible to
pick up the sound from the speaker of the TV. The microphone input level can be adjusted
for this input.
See the outputs in the rear panel at the previous picture.
Start by controlling your TV's audio outputs and the outputs of the other input sources
you want to connect. Consult the manual for each source for information on audio outputs
(RCA, Scart etc.)
Purchase the right cable/s if you haven't done that in connection with the purchase of your
Univox® DLS-50. You find a list of cables and other related parts in section Accessories.
Connect your TV and/or other sound sources to the Univox® DLS-50 with the chosen cable
according to the following guidelines:
TV/other sound sources
Connect TV, stereo etc. to the line input (Line). If you want to connect both TV and for
example stereo, use the line input (Line) for one of the sound sources and the combined
mic/line input (Mic/Line) for the other sound source.
If you watch TV by cable/satellite and also have a VHS or DVD player, we recommend to
connect an automatic Scart control (AutoScart, read more in section Accessories).
For connection to the TV's Scart output an ordinary Scart cable can also be used with a
Scart connector at one end and a 3.5mm connector at the other end (Scart2, see section
Accessories).
5
Advertisement
Table of Contents
