Advertisement
Chair adjustments
Centre of gravity (std.)
To adjust the centre of gravity (Fig.
37) remove the wheel, by
unscrewing the 19mm A/F retaining
nut (1, if quick release axles are not
fitted), the wheel spacer (2, if
fitted), the axle (3), the two bracket
retaining bolts (4) and nuts (5) using
10mm
A/F spanners. Move the
bracket (6) to the rear position, as
shown, and replace the bolts and
retaining nuts and tighten them to 8-
10Nm torque setting, replace the
axle in the required hole (7) and
tighten to 81Nm. Relpace the
wheel, spacer and retaining nut and
tighten to 45Nm.
Note:
After adjusting the axle position the
front castors must be checked for
adjustment (see page 31, Fig. 42).
Camber adjustment
The rear wheel camber is preset at
O
the factory at 2
(Fig. 38), but it can
be adjusted by loosening the axle
plate (1) top retaining nuts (2) and
screws (3) and removing the bottom
retaining nuts (4) and screws (5)
ensuring that the camber washer (6)
is retained. Insert an additional
camber washer and re-assemble
using 10mm A/F spanners,
tightening the nuts and screws to 8-
10Nm torque.
Issue 2
5
7
Fig. 37
2
1
4
6
Fig. 38
29
4
3
2
1
6
3
5
RX Kidz
Advertisement
