Advertisement
Chair features
Wheel locks
High mount push-to-lock wheel
locks are shown in (Fig. 23). The
wheel lock mounts on a clamping
system (1) and is correctly set prior
to leaving the factory. To apply the
wheel lock simply push the
operating lever (2) forwards until
you feel it go over centre, and the
grip bar (3) grips the tyre (4). The
operating lever (2) can have a
detatchable extension which can
be removed to create space for
side transfers. When the wheel lock
is applied remove the operating
lever extension by pulling it off the
brake. Refit when you are
reseated. It is attatched by a cord
to the wheel lock and cannot fall
off.
Knee brake
Operating position and adjustment
instructions for the kneebrake wheel
lock are shown in Fig. 24.
Slaken the two screws (1) on the
wheel lock clamp and slide the
brake to achieve the correct wheel
lock gap, then retighten.
The wheel lock gap (2) (which is the
gap between the nearest point of
the wheel lock and the tyre) should
be 3mm with pneumatic tyres (tyres
filled with air) and 5mm with solid
tyres, when the wheel lock is in the
released position.
Issue 2
1
4
Fig. 23
1
Fig. 24
21
2
3
2
RX Kidz
Advertisement
