Advertisement
Chair adjustments
Knee lever brake and wheel lock adjustment
To adjust, loosen the two screws on each clamp, and the screws on the
underside of each clamp. Using a 5mm Allen key turn one of the screws
anticlockwise ¼ turn. Repeat the process with the other screws. Loosen the
four screws until the clamp can slide freely. Slide the clamp towards the
rear wheel until the grip bar embeds into the tyre approximately 4mm (3/
16") when in the locked position. Tighten the screws to a torque setting of
15Nm. Some adjustments to the wheel lock position can be accomplished
without moving the clamp. To adjust, loosen the four screws as above.
Slide the mounting bar forward or backwards and rotate it to the correct
angle position. The grip bar should embed into the tyre approximately 4mm
(3/16") when in the locked position. Tighten the screws to a torque setting
of 15Nm.
Warning:
Wheel locks/knee lever brakes when properly adjusted, prevent the rear
wheels from turning when the chair is stationary. Always adjust the wheel
locks after making any changes to the rear axle sleeves position, so that the
grip bar embeds into the tyre approximately 4mm (3/16") when in the
locked position.
RX Kidz
26
Issue 2
Advertisement
