Permobil Chairman Operator's Manual page 17

10. Detach the seat lift by drawing it straight up.
11. Clip off the wiring bundle tie holding together the
seat lift cabling, follow the cabling to its end, and
loosen the contact at the SLS Drive, as well as
the conductor joint located beside the SLS Drive,
prior to detaching the SLS Drive, see page 24.
The upper part of the seat lift is mounted on the
seat and can be detached as described in the
following.
12. Unscrew and remove the two screws holding
the seat plate, see fig. 28.
13. If the seat is equipped with seat tilt, unfasten
the actuator's front bracket, see fig. 29. Draw
the seat tilt mechanism apart, see fig. 30.
14. Unscrew and remove the four screws holding
the seat lift, see fig. 30 and 31.
Fitting
Fitting is the reverse procedure.
Fig. 30. Seat with seat tilt, the upper part of the
seat lift is mounted with four screws.
Fig. 28. The seat plate is mounted with two screws.
Fig. 29. Unfasten the front bracket on
the seat tilt actuator.
Fig. 31. Seat without seat tilt, the upper part of
the seat lift is mounted with four screws.
17
Seat lift