Seat Lift - Permobil Chairman Operator's Manual

Drive motor
10. Remove the three bolts holding the motor.
11. Turn the motor sideways to free the wheel shaft.
Pull the motor straight forwards.
Fitting
Fitting is the reverse procedure.

Seat lift

Removal
1. Raise the seat using the accompanying seat
lift crank, see page 7. Raise the seat until it will
not go any higher while you crank, i.e. the seat
lift is "not engaging".
2. Switch off the main power switch on the
control panel.
3. Set the main fuse to the "OFF" position,
see page 23.
4. Detach the seat lift and chassis covers,
see page 8.
5. Clip off the wiring bundle tie mounted on the
cabling between the seat and the chassis.
6. Loosen the seat lift motor's cable connection,
pay attention to the placement of the cables
for purposes of later remounting, see page 21.
7. Lift out the seat, place it on its side next to the
chassis, see Fig. 27.
NB! The seat is heavy, hence there should be two
people to do this. Be careful with the cabling
8. Unscrew and remove the two screws on the
seat lift's upper fastener, see fig. 27:1.
9. Remove the two screws on the seat lift's lower
fastener, see fig. 27:2.
Fig. 25. Drive motor mounting bolts.
Fig. 26. Removing a drive motor.
Fig. 27. Lift out the seat.
16
1
2