Advertisement
CONNECTIONS FOR REGULAR OR BALANCED INPUTS:
The CLASSÉ S-1000 power amplifier is equipped with both regular and balanced inputs. Either
one may be used
SEPARATELY BUT NOT SIMULTANEOUSLY
preamplifier which has balanced main outputs, and balanced interconnects with
also required. Regardless of the amplifier inputs used, stereo or mono operation is still possible on the
S-1000.
REGULAR INPUTS
The amplifier is factory set for
jacks on the rear panel of the S-1000, and make sure the toggle switch lever is closest to the position
marked
. (The
REGULAR
BALANCED "XLR"
BALANCED INPUTS
A balanced preamplifier and balanced interconnects are also required. For use with balanced
preamplifiers other than Classé, the wiring of the 3-pin
Classé S-1000 which is wired as follows:
PIN 1: GROUND
PIN 2: POSITIVE (NON-INVERTED) SIGNAL
PIN 3: NEGATIVE (INVERTED) SIGNAL
If the pin configuration of the preamplifier differs from above, the balanced interconnects must be
modified to accommodate the different preamp.
Having confirmed the correct connections, plug the
interconnects into the locking
connectors, press the tab above the connector.) Disconnect the S-1000 from the A.C. line. Make sure
the toggle switch lever is switched from the REGULAR to the BALANCED position. This activates the
balanced inputs and disables the regular inputs.
use. Connect the regular interconnects to the
REGULAR
input connectors are automatically disable.).
XLR
connectors on the rear panel of the S-1000. (To remove the
XLR
-7-
. The balanced inputs must be connected to a
"XLR"
connectors must be matched to that of the
connectors of the balanced
XLR
connectors are
input
RCA
Advertisement
