Advertisement
MONO
Firstly, please read through the previous Stereo section for general notes on securing good
connections, and safety tips. If the unit has been previously used in stereo, make sure it is OFF, and
remove all connections. The STEREO/MONO switch is located on the back panel above the input
jacks. The lever should be closest to the position marked MONO.
The MONO input is the left channel input, as marked. The unused right channel input is
automatically disconnected. The output connections are marked BELOW the connectors. (The MONO
positive is the left positive; the MONO negative is the right positive.)
Repeat the above MONO settings and connections on the second S-1000 to be used for the other
channel.
Please remember that the negative output connection of a bridged amplifier is NOT a ground.
Do not use a "common ground" or switchbox set-up. Do not use with electronic crossovers which have
a common ground.
-6-
Advertisement
