Code Approval - Vermont Castings BLDV300N SC7SB Installation And Operating Instructions Manual

BLDV7 Series Gas Fireplace
14. Do not use any solid fuels (wood, coal, paper, card-
board, etc.) in this fireplace. Use only the gas type
indicated on rating plate.
15. This appliance, when installed, must be electrically
grounded in accordance with local codes or in the
absence of local codes, with the National Electrical
Code, ANSI/NFPA 70, or the Canadian Electrical Code,
CSA C22.1.
16. Do not obstruct the flow of combustion and ventilation
air in any way. Provide adequate clearances around air
openings into the combustion chamber along with ade-
quate accessibility clearance for servicing and proper
operation.
17. When the appliance is installed directly on carpeting, tile
or other combustible material other than wood flooring,
you must set appliance on a metal or wood panel or
hearth pad extending the full width and depth of the
appliance.
18. Do not use fireplace if any part has been exposed to
or has been under water. Immediately call a qualified
service technician to inspect the appliance and replace
any part of the control system and any gas control which
as been submerged in water.
19. Do not operate fireplace if any log is broken.
20. Do not use a blower insert, heat exchanger insert, or
any other accessory not approved for use with this
fireplace.
21. Do not operate the fireplace with glass door removed,
cracked, or broken.

CODE APPROVAL

Direct Vent type appliances draw all combustion air from
outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to
comply with the established standards for VENTED GAS
FIREPLACE in the USA and Canada as follows:
LISTED VENTED GAS FIREPLACE
TESTED TO (latest edition):
BLDV300: ANSI Z21.50 / CSA 2.22
BLDV400/500: ANSI Z21.88 / CSA 2.33
STANDARDS
A manufactured home (USA only) or mobile home OEM
installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part
3280, or when such a standard is not applicable, the
Standard for Manufactured Home Installations, ANSI/
NCSBCS A225.1, or Standard for Gas Equipped Recre-
ational Vehicles and Mobile Housing, CSA Z240.4.
4
IMPORTANT SAFETY INFORMATION & CODE APPROVAL
PLEASE READ THE FOLLOWING CAREFULLY
It is normal for fireplaces fabricated of steel to give off
some expansion and/or contraction noises during the start
up or cool down cycle. Similar noises are found with your
furnace heat exchanger or car engine.
PLEASE READ THE FOLLOWING CAREFULLY
It is not unusual for gas fireplace to give off some odor
the first time it is burned. This is due to the manufacturing
process.
Please ensure that your room is well ventilated during
burn off — open all windows.
It is recommended that you burn your fireplace for at
least ten (10) hours the first time you use it. Place the fan
switch in the "OFF" position during this time.
Never connect unit to private (non-utility) gas wells. This
gas is commonly known as wellhead gas.
• Improper installation or use of this fireplace can cause
serious injury or death from fire, burns, explosions,
electrical shock and carbon monoxide poisoning.
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this
IMPORTANT:
IMPORTANT:
WARNING
DANGER
HOT GLASS WILL
Nous recommandons que nos
CAUSE BURNS.
appareils de chauffage au gaz
soient installés et entretenus par
DO NOT TOUCH GLASS
des professionnels qui ont été
UNTIL COOLED.
accrédités aux È.U. par le National
Fireplace Institute ® (NFI) comme
NEVER ALLOW CHILDREN
étant des spécialistes du NFI en
TO TOUCH GLASS.
matièred'appareils de chauffage
au gaz.
appliance and shall be installed.
DANGER
20306741