Installing Drivers For The Citrix Xenserver Hypervisor - Lenovo ThinkServer RD340 Operating System Installation Manual

15. In the System Time window, depending on your needs, select Using NTP to set the time through
Network Time Protocol (NTP) or select Manual time entry to type the time information at the end of
the installation. Then select OK and press Enter.
16. In the Confirm Installation window, select Install XenServer and then press Enter to start the installation.
17. In the New Media window, configure the settings as you need. Select Skip and then press Enter.
18. Set your time and date in the Set local time window, select OK, and then press Enter.
19. When the installation is completed, a notification window is displayed. Select OK and press Enter
to restart your server.
20. Remove the disc from the optical drive after the whole process is completed.

Installing drivers for the Citrix XenServer hypervisor

This topic provides instructions on how to install drivers for the Citrix XenServer hypervisor.
To install drivers for the Citrix XenServer hypervisor, do the following:
1. Download the drivers from the Lenovo Web site. Copy the qla2xxx.iso file to your USB storage device
and connect the USB storage device to your server. The most up-to-date device drivers for various
server models are always available on the Lenovo Web site at:
http://www.lenovo.com/drivers
2. Use the following commands to install the drivers:
mkdir -p /mnt/tmp
mount /dev/sdb1 /mnt/tmp
mount /mnt/tmp/qla2xxx.iso /mnt/tmp -o loop,ro
cd /mnt/tmp/
./install.sh
umount /mnt/tmp
Note: In the command lines, sdb1 represents the drive letter of your USB storage device; qla2xxx.iso
represents the name of the driver package file; and install.sh represents the driver name. Use the
corresponding file name on your server.
3. Restart your server.
.
Chapter 2 Installing an operating system in legacy mode
49