Installing The Driver For Intel Management Engine Interface; Installing The Driver For An Hba Card; Installing The Driver For A Cna Card; Installing The Hyper-V Server 2012 Operating System - Lenovo ThinkServer RD340 Operating System Installation Manual

Installing the driver for Intel Management Engine Interface

To install the driver for Intel Management Engine Interface, do the following:
1. Copy the driver for Intel Management Engine Interface from the ThinkServer EasyStartup DVD that
comes with your server to a USB storage device. Connect the USB storage device to your server.
2. Use the following commands to install the driver:
e:
cd Management
Pnputil –i –a *.inf
Note: In the command lines, e: represents the drive letter of your USB storage device and Management
represents the name of the folder where the driver is stored.
3. Restart your server after the installation is completed.

Installing the driver for an HBA card

To install the driver for an HBA card, do the following:
1. Copy the driver for an HBA card from the ThinkServer EasyStartup DVD that comes with your server to a
USB storage device. Connect the USB storage device to your server.
2. Use the following commands to install the driver:
e:
cd HBA
Pnputil –i –a *.inf
Note: In the command lines, e: represents the drive letter of your USB storage device and HBA
represents the name of the folder where the driver is stored.
3. Restart your server after the installation is completed.

Installing the driver for a CNA card

To install the driver for a CNA card, do the following:
1. Copy the driver for a CNA card from the ThinkServer EasyStartup DVD that comes with your server to a
USB storage device. Connect the USB storage device to your server.
2. Use the following commands to install the driver:
e:
cd CNA
Pnputil –i –a *.inf
Note: In the command lines, e: represents the drive letter of your USB storage device and CNA
represents the name of the folder where the driver is stored.
3. Restart your server after the installation is completed.

Installing the Hyper-V Server 2012 operating system

This topic provides instructions on how to install the Hyper-V Server 2012 operating system.
To install the Hyper-V Server 2012 operating system, do the following:
1. Insert the operating system installation disc into the optical drive that you have set as the first startup
device. Then, start the server from the optical drive.
2. When the message Press any key to boot from cd or dvd... is displayed, press any key. If the message
Windows Setup [EMS Enabled] is displayed, press Enter. Wait several minutes for the system to load
the files.
.
Chapter 2 Installing an operating system in legacy mode
43