GRAPHTEC FC7000-75 Service Manual page 54

How to reinstall the Y-belt
(1) Shave 2 to 3 mm off both ends of the Y-belt until the wire comes out as shown below.
(2) Hang the Y-belt on both sides of the pulley.
(3) Attach both ends of the Y-belt to the Y-slider so that four notches of the Y-belt fi t into the Y-slider, then
attach with the Y-belt stopper plates removed in step (5) in the previous subsection.
M3L6 binding head screw
(4) Attach the pen block (see Subsection 6.2.5).
(5) Reattach the other parts in the reverse order in which they were detached.
(6) Perform the Y-belt tension adjustment. (see Subsection 7.2.1).
FC7000-UM-251-9370
6. DISASSEMBLY AND REASSEMBLY
Y-belt
Shave 2 to 3 mm off both ends of
the Y-belt until the wire comes out.
Y belt
Four notches of the Y-belt fi t into
the Y-slider.
6-16