GRAPHTEC FC7000-75 Service Manual page 18

Cutting plotter
Table of Contents

Advertisement

(4) Mount the plotter on the stand by inserting the positioning pins on the stand into the positioning holes
on the underside of the plotter. Fasten with four socket head cap screws (two on each side), using the
Allen wrench.The cutting plotter mounting direction is different for the front loading and the rear loading
models.
Socket head
cap screws
Positioning pin hole
Caster stoppers
(5) Tighten the socket head cap screws loosely fastened in Step 2.
FC7000-UM-251-9370
<Front loading>
Socket head
cap screws
Positioning pin
• Check that all of the screws used for fastening have been tightened. The media
may not be fed correctly if even one of the screws is loose.
• When installing the plotter, make sure that there are no objects in its vicinity.
Leave a clear space of at least 300 mm around the plotter.
2. PARTS NAMES and FUNCTIONS
<Rear loading>
2-6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents