Error Messages In Gp-Gl Command Mode - GRAPHTEC FC7000-75 Service Manual

9.4.2 Error Messages in GP-GL Command Mode

Error Display
ERROR 1
COMMAND ERROR
ERROR 4
PARAMETER OVERFLOW
ERROR 5
I/O ERROR
FC7000-UM-251-9370
Cause
The plotter received (1) Did the plotter
an unrecognizable
command.
(2) Is there any noise on
(3) Has the correct
• The software The numeric parameter
configuration of an input command
regarding the exceeds its permissible
output device range.
An error related to the
has been
receipt of data occurred
changed.
within the interface.
• The plotter's
interface
conditions have
been changed.
9-5
Verification item
No .....Verify item (2)
receive an Yes ....Send correct data to
unrecognizable
command?
No .....Verify item (3)
the line? Yes ....Check the interface
No .....Set the correct model
model name been
set for the plotter? Configure your software
application menu to permit
Graphtec plotter control.
Re-specify the software
application's interface
conditions.
Configure your software
application menu to permit
Graphtec plotter control.
Re-specify the software
application's interface
conditions.
Set the correct model name
if it was incorrect.
9. TROUBLESHOOTING
Solution
plotter.
cable or move the
plotter to another
location.
name.