Acticare TSE User Manual page 39

To change between TENS/TSE and
Interferential modes
underside of the device.
Therapy Mode Switch
TSE & TENS
To check therapy mode preset
device on using the key. The mode is
displayed for one second as the device
switches on.
You should always check you are in the
desired mode when you turn on
Acticare IC prior to treatment. The
default preset mode is TSE1 in
TENS/TSE and PROG1 for Interferential
Current (IC).
To restore factory settings.
device off and hold down the TIMER
while you turn the unit on with the ON/OFF
key. The device should display all segments
followed by the software revision number
before starting up normally.
use the switch on the
IC
turn the
Start with the
key
36
Quick Reference
To change therapy mode
and TIMER buttons
same time . The display should flash
"MODE MENU" as confirmation.
If you see the TIMER setting screen
this means you did not press both
keys together. Press
try again.
Press or to select the mode
to use. Each press of
to cycle through the available modes (for a
list of Interferential modes see page 9,
TSE page 15, TENS page 21).
Press and hold TIMER
exit and save settings.
press the
together at the
to exit and
you wish
causes the menu
for 1 second to
13