Quick Reference - Acticare TSE User Manual

The Acticare IC device has 4 buttons.
On/Off
button
To turn the device on
To turn the device off
one second.
To adjust the treatment timer
Press the TIMER
button to
enter timer
setting mode
Use & to
adjust time
Press and hold
for one second to
13
save your new
time.

Quick Reference

Plus button
Timer
button
Minus button
press .
press and hold
To start treatment
Each press increases intensity by 1% in
TENS/TSE modes or 1mA in Interferential
modes. Hold the button down to increase
intensity quickly.
The treatment intensity is displayed as a bar
graph and also as a percentage or in mA
(highlighted in red in the diagram below).
Intensity Level
Bar Graph
for
Intensity Level %
Some people mistake the intensity %
for an indication of TSE and TENS
preset modes 1, 2, 3 etc. The figure
"1" on the display means an intensity
of only 1% or 1mA in Interferential
modes. The active preset is only
displayed for one second when the
unit is switched on.
To increase or decrease treatment
intensity during treatment,
buttons. Each press changes intensity by
1% or 1mA. Hold the button down to change
quickly.
To stop treatment
button to quickly reduce intensity. When the
treatment level reaches zero the treatment
stops automatically. Alternately, you can stop
treatment by turning the device off.
35
press the button.
press the or
press and hold the