Acticare TSE User Manual page 23

STEP 5. Completion of treatment
Treatment has ended when the timer has
finished counting down and the message
"TREATMENT COMPLETE" is displayed. The
device will also bleep to indicate that
treatment is over.
You can end a treatment before the timer has
finished by turning off the device.
To turn off the device hold down the ON/OFF
button for 1 second.
After every treatment, we recommend that
you return the electrodes to their backing
sheet and store them in the sealable bag to
prevent them from drying out. Always stick
the electrodes to the correct side of the
backing sheet as marked (usually by the
symbol: "on").
If the message "CHECK LEADS AND
PADS" is displayed, check that the
electrodes and lead wires are correctly
connected to the device. Check also
that the electrodes are properly stuck
to the skin. Once electrodes have been
properly connected you can increase
the power to the desired level.
See section 10 "Troubleshooting" for
more information.
Caution. With TSE 1 and TSE 2
especially, the electrodes may get
warm during treatment. If they do
check that they are properly stuck to
the skin and reduce the intensity by
about 25%.
Adjusting the treatment timer
Whenever you start a treatment, the Timer
automatically uses the last treatment time.
You can however adjust the Timer at any time
before or during a treatment.
See page 15 for advice about deciding the
best treatment time.
To change the treatment timer, press the
TIMER button to display the Timer screen.
Timer Setting Screen
Press + or – to increase or decrease the timer
to the desired time. You can select times
between 10 minute and 3 hours If the timer s
is set to OFF the treatment will run until
stopped manually.
Press the TIMER
confirm the setting. Acticare IC will go back to
the Running screen with your new treatment
time shown.
20
TSE Mode
.
button for 1 second to
6