Installing Batteries - Acticare TSE User Manual

Charging Batteries

Installing batteries

Your device is supplied with four AA
rechargeable Nickel Metal Hydride (NiMH)
batteries.
1. Open the battery cover
blue catch as shown.
4
2. Insert four AA batteries
polarity is correct. The correct polarity is
indicated by symbols in the battery
compartment.
3. Close the battery cover.
secure. If the batteries are correctly installed
the battery symbol
on the screen.
Using the charger / mains power cradle
by squeezing the
making sure the
Check that it is
will be displayed
7
The fast charge cradle provides a full charge
in 2½ hours. To charge batteries, plug the
device into the charger stand as shown below.
If you need to use the device straight away,
you can operate from mains power while in
the cradle.
Make sure you push the device fully into the
cradle to ensure proper contact. An
intermittent beeping means that the device is
not pushed completely in.
The battery symbol will scan to indicate that
the battery is charging. If the battery is not
charging check to make sure the charger is
plugged in and the socket is switched on.
When the batteries are fully charged the
battery symbol shows full.
Battery
Low
Acticare IC can be used for treatment
when it is on the charger stand, but
the batteries will only be charged
when the device is switched off.
Battery
Full