Table of Contents
Advertisement
D
W
L
ECIDING
HERE TO
1. Do not install the stove in a bedroom or room where people sleep in.
2. Locate the stove in a large and open room that is centrally located in the house. This will optimize
heat circulation.
3. Check clearances to combustibles and for the least amount of interference to house framing, plumbing,
wiring, etc.
4. You can vent the stove with approved pipe through an exterior wall behind the unit or pass it through
the ceiling and roof. The stove can connect to an existing masonry or metal chimney (must be lined
if the chimney is over 6" (15 cm) diameter, or over 28 inches² (180 cm²) cross sectional area).
5. This unit must not be installed directly onto carpet. If it is to be installed on a carpeted area, a solid
surface (wood, metal or approved hearth pad) must be installed between the unit and the carpet.
6. This unit uses large quantities of air for combustion; outside Fresh Air connection is strongly
recommended. Fresh Air must be connected to all units installed in Mobile and "Air Tight Homes"
(R2000) or where required by local codes.
7. Do not obtain combustion air from an attic, garage or any unventilated space. Combustion air may be
obtained from a ventilated crawlspace.
8. The power cord is 8 feet (2.43 m) long and may require a grounded extension cord to reach the
nearest electrical outlet.
R
P
S
EMOVING
ELLET
TOVE
REPLACE THESE SCREWS AFTER
REMOVING FROM PALLET. (2 EACH
SIDE)
Figure 3: Screws to take out to remove stove from pallet.
8
Installation
P
A
OCATE YOUR
ELLET
PPLIANCE
F
P
:
ROM
ALLET
:
Hampton GC60 Cast Pellet Stove Technical Manual
1. Remove the two (2)
screws that hold the
brackets to the pallet on
either side of the unit.
2. Remove the two (2)
5
/
" hex head screws
16
that hold the brackets to
the units.
Hide quick links:
Advertisement
Table of Contents
